- Home
- Equipment
Refine by
Teledyne Oldham Xprt Equipment & Supplies
22 equipment items found
Premium
Manufactured by:Teledyne Gas and Flame Detection based inArras Cedex, FRANCE
The MultiSafe-MX system is intended for the protection of high hazard, high risk plant and facilities. The MultiSafe-MX is certified, by European laboratories, to comply with the applicable regulations. The panel is composed of dedicated cards, installed in 19” racks which have their own “intelligence”, programmed for active/passive fire protection, gas detection, intruder alarm ...
Premium
Manufactured by:Teledyne Gas and Flame Detection based inArras Cedex, FRANCE
When hazardous levels of toxic gases or oxygen threaten the safety of an unclassified area, the CTX 300 detector can satisfy the most demanding safety requirements. The CTX 300 detector is designed to detect oxygen, toxic and refrigerant gases, and also uses a new sensor for CO2 detection over three different ranges: 0-5000 ppm, 0-5% vol. and 0-100% vol. The CTX 300 transmits data in ...
Premium
Manufactured by:Teledyne Gas and Flame Detection based inArras Cedex, FRANCE
Infrared Gas Detector - 1 or 2 Points of Detection from a Single Head. The iTrans2 infrared gas detector employs an intelligent electronics platform to provide one or two points of detection from a single head for maximum flexibility, superior performance and lower installation costs. With the optional HART Communication Protocol, the iTrans2 offers remote diagnostics, set-up or calibration by ...
Premium
Manufactured by:Teledyne Gas and Flame Detection based inArras Cedex, FRANCE
The OLCT 10N is a digital combustible gas detector designed for to detect combustible, toxic gases or oxygen. Intended for use in combination with the MX 16, MX 32 and MX 43 controller, the OLCT 10N provides a fast and accurate response. All transmitter information is received by the controller in less than 1 second. Non-intrusive operator interface requires only a simple magnetic wand and ...
Premium
Manufactured by:Teledyne Gas and Flame Detection based inArras Cedex, FRANCE
We introduce the new MX 32, a controller that takes analog & digital inputs and covers all needs for a wide variety of applications. The MX 32 is a compact, low-profile controller that continuously monitors gas detection and more generally any 4-20 mA, MODBUS RS485 signal from compatible ...
Premium
Manufactured by:Teledyne Gas and Flame Detection based inArras Cedex, FRANCE
Designed for the detection of explosive gases, toxic gases or oxygen, this gas detector comes with a Wheatstone bridge output (OLC 100) or 4-20mA output (OLCT 100). Whatever your application Teledyne Gas and Flame Detection offers a solution: MEMS, catalytic, electrochemical, semiconductor, or poison control version. ATEX approved, these detectors are available in explosion safe or intrinsically ...
Premium
Manufactured by:Teledyne Gas and Flame Detection based inArras Cedex, FRANCE
The GD10 Series has been designed with features that provide an effective response to the detection of gas hazards in a wide range of industrial environments from boiler plant rooms to offshore petrochemical installations. These infrared gas detectors differ from all other models, because they utilize silicon based solid-state infrared sources. The complete optomechanical design and ...
Premium
Manufactured by:Teledyne Gas and Flame Detection based inArras Cedex, FRANCE
The GD1 has been designed with features that provide an effective response to the detection of gas hazards in a wide range of industrial environments from offshore production facilities to wastewater treatment plants. At the heart of the detector is a tuneable laser diode that eliminates environmental effects from sun, rain and fog. The laser scans single absorption lines where there is no ...
Premium
Manufactured by:Teledyne Gas and Flame Detection based inArras Cedex, FRANCE
Teledyne Gas and Flame Detection has designed the SURVEYOR 4B as a monitoring apparatus specifically designed to ensure the safety of boiler plants, battery charging rooms or small units where your operations are at risk due to the possibility of flammable gas leaks. Developed for quick, safe detection, the SURVEYOR 4B control module combines highly reliable monitoring, simple implementation and ...
Premium
Manufactured by:Teledyne Gas and Flame Detection based inArras Cedex, FRANCE
Oldham is pleased to propose its wireless system with the OLCT 80 field detector/transmitter. This model allows wireless connectivity in ATEX 1 ...
Premium
Manufactured by:Teledyne Gas and Flame Detection based inArras Cedex, FRANCE
The OLCT 60AD version allows the sensor to be installed remotely up to 15 meters (standard), allowing detection in inaccessible locations, or in Zone 0 in the case of the intrinsically safe (IS) version. The detector units are made of 316L stainless steel, and are rugged and resistant to corrosion. Pre-calibrated sensors can be disconnected by turning the head of the unit. These ...
Premium
Manufactured by:Teledyne Gas and Flame Detection based inArras Cedex, FRANCE
The MX 16 is a compact digital or analog controller, one input, low-profile controller that continuously monitors gas detection, like: O2, CO2, CH4, H2, LPG. Specially designed for applications in laboratory, storage, small boiler room, and breweries or battery charging rooms, the MX 16 measuring unit prevents the risks of explosion linked to the presence of toxic, anoxic and explosive gases in ...
Premium
Manufactured by:Teledyne Gas and Flame Detection based inArras Cedex, FRANCE
The stainless steel detector provides protection and resistance to corrosive agents. Classified IP 66, they are resistant to dust and water ingress. The precalibrated sensors of the OLCT 20 can be disconnected by turning the head of the unit. These “smart” sensors can be calibrated on a work bench, outside hazardous ...
Premium
Manufactured by:Teledyne Gas and Flame Detection based inArras Cedex, FRANCE
The OLC 10 and OLCT 10 are designed to detect combustible or toxic gases for tertiary applications (boiler plants, battery charging rooms, car parks, hospitals). Two OLC 10's can be connected to one detection channel to monitor the same area, without an additional junction box or extra wiring. Similarly, up to five OLCT 10's can be connected to one channel for the detection of CO, NO or NO2 in a ...
Premium
Manufactured by:Teledyne Gas and Flame Detection based inArras Cedex, FRANCE
An attractive solution for gas and flame detection needs, the MX 62 is a modular and flexible controller that is easy to install and reduces operational costs. The MX 62 system meets the requirements of ATEX 100 A and offers the high level of security required by SK2 and SIL3 rated ...
Premium
Manufactured by:Teledyne Gas and Flame Detection based inArras Cedex, FRANCE
Teledyne Gas and Flame Detection is proud to introduce its wireless system with the OLCT 80 field detector/transmitter. This new model allows wireless connectivity in ATEX 1 zones. The maximum range is 3km, line of sight. The type of network selected will depend on the number of field detectors, the area coverage and the network ...
Premium
Manufactured by:Teledyne Gas and Flame Detection based inArras Cedex, FRANCE
Fully scalable, and designed to functional safety performance level 1 standards, the MX 43 is an analog and digital controller that continuously measures and controls gases in the atmosphere. The MX 43 gas detector manages both digital lines and analog channels, and covers all needs for a wide variety of gas monitoring applications. The MX 43 digital technology allows up to 32 detectors to be ...
Premium
Manufactured by:Teledyne Gas and Flame Detection based inArras Cedex, FRANCE
The MX 256 is a digital control unit intended for the detection and measurement of gases present in the atmosphere and more generally for the processing of any digital signal from digital sensors (OLCT 10N types), relay module, analog output module, logic input module. Thanks to its new option, an industrial controller module or remote HMI, it is possible to add analog input modules for ...
Premium
Manufactured by:Teledyne Gas and Flame Detection based inArras Cedex, FRANCE
The MultiFlame DF-TV7–T is a multi-spectrum infrared flame detector using three wavelengths. The MultiFlame DF-TV7-T responds to hydrocarbon fires and is the right choice for operation in dirty environments or for detection of smoky fires. The MultiFlame DF-TV7–T is designed to respond to unwanted hydrocarbon fires, whilst maintaining a high degree of false alarm immunity. The device ...
Premium
Manufactured by:Teledyne Gas and Flame Detection based inArras Cedex, FRANCE
The CPS car park air monitor accurately and reliably protects the public and employees from airborne toxic gases in parking facilities and tunnels. The system was designed to comply with the high air quality safety standards enforced in such European countries as Germany, the Netherlands and ...